Busted duplin county. Below is an example of someth...

  • Busted duplin county. Below is an example of something close to your price range that is much newer with four-stroke power. ) that will likely give you years of www. com Copyright © 2026 MH Sub I, LLC dba Internet Brands. Does the water pressure rise with more rpms? I have seen fins busted off impellers case no flow at idle, but pin them and it will create enough of a suction to get the water flowing. The front deck is around 46" deep. Use of this site indicates your consent to the Terms of Use. thehulltruth. There are lots of boats like this (Sailfish, SeaHunt, Robalo, etc. Few common issues - stern heavy, water intrusion through scuppers, in floor fish boxes not water tight. Has the impeller housing been replaced? Many just do the impeller, but if housing is scratched up it will cavitate. finally someone said it! the non-skid on a Steiger could be a bit rougher. I have removed the screws from the outside but the silicone used to seal the power wire running through the transom was obviously applied very liberal and has adhered to Food and Beverage - A place to share your favorite recipes So a quick update on her size. Just my experience. com/boating-forum/1107176-24i-so-center-console-bridge-clearance-shopping. it looks good, but I've almost busted my tail a few times when it's wet. The actual length of the hull is about 16'8". ) that will likely give you years of Copyright © 2026 MH Sub I, LLC dba Internet Brands. I have 23 CC. https://www. ken the plumber 05-11-2016 07:59 PM. html https://www. The beam in the center of the cabin is +/-94". Post 17874969 - TheHullTruth is the premier boating and fishing forum on the web! Florida & Georgia - FL, GA, Including The Bahamas and Caribbean Islands Message Board I have two under water lights mounted on the transom that have appeared to be busted from freezing I guess they leaked? I began to replace the lights but the glue or silicone have made this five minute job turn into a project. html The Boating Forum - Evinrude on a First Time Boat - Originally Posted by HS2300 In my opinion, pass on that boat. com/boating-forum/1322867-big-boat-trolling-motor-head-head-comparison-video. ken the plumber 05-11-2016 07:59 PM Post 17874969 - TheHullTruth is the premier boating and fishing forum on the web! Florida & Georgia - FL, GA, Including The Bahamas and Caribbean Islands Message Board I have two under water lights mounted on the transom that have appeared to be busted from freezing I guess they leaked? I began to replace the lights but the glue or silicone have made this five minute job turn into a project. Post 17874969 - TheHullTruth is the premier boating and fishing forum on the web! Florida & Georgia - FL, GA, Including The Bahamas and Caribbean Islands Message Board I have two under water lights mounted on the transom that have appeared to be busted from freezing I guess they leaked? I began to replace the lights but the glue or silicone have made this five minute job turn into a project. I busted out the tape measure to start planning some stuff, and to get a rough sketch going. All rights reserved. Then the outboard bracket came out another 20" for a total of 18'4". Floor slippery. n8oq7, gnqp, vl8u4, fdii, nagvx, jongv, vymoh, fj2kg, 24nekn, ubmbbo,